 |
 |
At Fri, 1 May 2009 09:51:19 -0500, Amanda P wrote: > > "On the other hand, there are projects like bkrpr [2] and [3], > home-brew scanning stations build for marginally more than the cost of > a pair of $100 cameras." > > Cameras around $100 dollars are very low quality. You could get no where > near the dpi recommended for materials that need to be OCRed. The quality of > images from cameras would be not only low, but the OCR (even with the best > software) would probably have many errors. For someone scanning items at > home this might be ok, but for archival quality, I would not recommend > cameras. If you are grant funded and the grant provider requires a certain > level of quality, you need to make sure the scanning mechanism you use can > scan at that quality. I know very little about digital cameras, so I hope I get this right. According to Wikipedia, Google uses (or used) an 11MP camera (Elphel 323). You can get a 12MP camera for about $200. With a 12MP camera you should easily be able to get 300 DPI images of book pages and letter size archival documents. For a $100 camera you can get more or less 300 DPI images of book pages. * The problems I have always seen with OCR had much to do with alignment and artifacts than with DPI. 300 DPI is fine for OCR as far as my (limited) experience goes - as long as you have quality images. If your intention is to scan items for preservation, then, yes, you want higher quality - but I can’t imagine any setup for archival quality costing anywhere near $1000. If you just want to make scans & full text OCR available, these setups seem worth looking at - especially if the software & workflow can be improved. best, Erik * 12 MP seems to equal 4256 x 2848 pixels. To take a ‘scan’ (photo) of a page at 300 DPI, that page would need to be 14.18" x 9.49" (dividing pixels / 300). As long as you can get the camera close enough to the image to not waste much space you will be getting in the close to 300 DPI range for images of size 8.5" x 11" or less.