My code is here:
http://staging.advanced-technology-group.com/?density=8&quality=grayscale&width=4&height=6&units=inches&index=0&zpl=%5EXA%0A%0A%5ECI28%0A%5ECWZ%2CE%3ATT0003M_.FNT%0A%5EFS%5EXZ%5EXA%5EFWN%5EFO70%2C50%5EA0%2C30%2C25%5EFH%5EFD_ce_8e%0A%5EFS%5EFO70%2C90%5EBY2%5EB3%2C%2C100%5EFDtestprodcuct%5EFS%5EXZ
The problem i face, is that i calibrate the zebra printer (gc 420t) with
the following: hold the feed button, the led blinks once, then twice, then
i release the feed button.
Then i notice that half of the label is not printed. Given that i use the
above offsets. What should one do? There are two ways to make the label
print correctly. Either with the printer make it print the label in the
middle, or with putting instead of 70, a larger value in the FS command.
How would you suggest i should proceed? If i use the code, is there a
command to use instead of FS, a command that would tell the printer to
print the label in the middle of the paper?
|